DISRAELI GEARS

Huret Route Touriste (1st style)

Huret Route Touriste (1st style) derailleur main image

Like the Huret Course Compétition, the Huret Route Touriste/Touriste Léger was one of Huret’s typically innovative and cunning designs, in this case a touring model that attached to a chainstay mount.

The pulley cage slides along a rod that is held in place by two thick rods (these are often referred to as ‘piano wire’ designs). A helical spring pushes the cage towards low gear, with the cable running directly between the outer plate and the cable clamp bolt on the inner plate pulls the pulley cage towards the high gear. The pulley cage is another elegant rod design, with chain tension provided by a spring (attached to the button on the pulley cage close to the guide pulley) that runs along the chainstay to a clip just behind the bottom bracket.

It was all very direct and simple, used materials that could be obtained during and immediately after the Second World War and could be manufactured in Huret’s simple workshops.

The Huret Route Touriste has steel chain pusher plates and weighs around 215g, while the Huret Touriste Léger has aluminium chain pusher plates and weighs around 185g. Without using a magnet or scales it is very hard to tell them apart.


I believe that this is an earlier example of a Huret Route Touriste, with no hole in the end of the aluminium outer cylinder. Some of its key features are:

  • The aluminium outer cylinder does not have a hole in its end.
  • The mounting wires are very angled to place the derailleur in front of the chainstay mount.
  • The chain pusher plates are aluminium, with an aluminium spring lug.
  • The plate holding the cable clamp bolt is flat, with no right angle bend.
  • Both pulley wheels are silver in colour and 35mm in diameter.
  • The brass nut at the tension pulley takes an 11mm spanner.


  • Derailleur brands: Huret
  • Categories: Huret - before 1950
  • Themes: Ultra-lightweight - long cage models
  • Country: France
  • Date of introduction: 1942?
  • Date of this example: unknown
  • Model no.: unknown
  • Weight: 210g including mounting bolts and spring (190g excluding spring)
  • Maximum cog: 28 teeth?
  • Total capacity: 34 teeth?
  • Pulley centre to centre: 70mm
  • Index compatibility: friction
  • Chain width: 1/8”
  • Logic: low normal
  • B pivot: none
  • P pivot: sprung
  • Materials: largely steel with aluminium outer cylinder and large nuts
Huret Route Touriste (1st style) derailleur additional image 01
Huret Route Touriste (1st style) derailleur additional image 02
Huret Route Touriste (1st style) derailleur additional image 03
Huret Route Touriste (1st style) derailleur additional image 04
Huret Route Touriste (1st style) derailleur additional image 05
Huret Route Touriste (1st style) derailleur additional image 06
Huret Route Touriste (1st style) derailleur additional image 07
Huret Route Touriste (1st style) derailleur additional image 08
Huret Route Touriste (1st style) derailleur additional image 09
Huret Route Touriste (1st style) derailleur additional image 10
Huret Route Touriste (1st style) derailleur additional image 11
Huret Route Touriste (1st style) derailleur additional image 12